Saeco Primea Touch Cappuccino Mode D'emploi page 16

If the user wishes to continue preparing other drinks the
machine will keep the "milk rinsing" signal active.
After 20 minutes of inactivity, the machine requires the user
to perform a rinsing cycle as described in Step 7.
If the machine is turned off immediately after dispensing a
milk beverage, the next time the machine is turned on it will
require the user to perform a rinsing cycle.
Note: Before performing the "milk rinsing" function make
sure that:
1. an adequate sized container is placed under the
dispensing head
2. the water tank is full of fresh water.
7
milk rinsing cycle
start
rinsing
To perform a rinse cycle,
press "start rinsing".
THIS PROCEDURE MUST BE PERFORMED FOR ALL MILK BEVERAGES!
AFTER USE, ALWAYS REMOVE THE MILK CONTAINER AND PUT IT IN THE REFRIGERATOR IF IT
show icon remove my custom
explanation milk coffee
REMOVE THE MILK CONTAINER ONLY WHEN THE MACHINE IS ON.
THE CONTAINER MAY BE LEFT IN THE MACHINE ONLY IF IT HAS BEEN WASHED WITH
DRINKING WATER AND IT DOES NOT CONTAIN MILK (SEE PAGE 40).
All manuals and user guides at all-guides.com
8
rinsing milk circuit-
please wait
rinsing...
Wait for the cycle to be completed.
After this, the machine returns to
the main menu.
CONTAINS REMAINING MILK.
After performing the rinse cycle, the machine reminds the user to
remove the container with the remaining milk through the message
program-
"remove milk".
ming
menu
milk
show icon my custom
explanation cleaning coffee
After 14 days from the fi rst dispensing of
a milk-based beverage, the message
"milk cleaning" is displayed; it is
advisable to clean the milk circuits as
shown on page 28.
After another 7 days the machine stops
dispensing milk-based beverages and the
milk circuits must be washed; during this
phase, coffee and hot water may be
brewed.
9
Remove the container and put
it in the refrigerator if it
contains remaining milk.
13
program-
ming
menu