Arregui PRINT Mode D'emploi page 9

CAUTION!
Do not store the emergency keys in the safe.
8. USING THE EXTERNAL BATTERY FEED
To carry out an opening with the external feed, proceed in the
following manner:
• Place 4 x 1,5V (AA) batteries in the external feed.
• Insert the feed connector in the current outlet located
on the lower left of the keypad. The box will emit a long
beep, indicating that it has a feed connection. Do not
remove the feeder until the opening procedure has been
completed.
9. INSTALLING THE SAFE
To reduce the risk of theft from the safe, it can be secured to
the floor, to a wall or inside a cupboard. For your convenience,
there are holes on the back and in the bottom, so it can be
fixed using anchor bolts.
Caution: the safe should be installed in a horizontal
position.
10. MAINTENANCE
• Check the condition of the battery compartment on a
regular basis (every 6 months) to identify any possible
signs of rust, sulphation, etc.
• Grease/oil any mechanical moving parts, such as locks
and bolts.
• Clean the fingerprint reader with a cloth dampened with a
little alcohol.
IMPORTANT
Recycling WEEE (waste electrical and electronic equipment)
is key as a safety measure in ensuring the health of people
and the environment. Always use specific collection centres
established for returning and managing used electrical
and electronic equipment. Before disposing of WEEE at a
collection centre, remove the batteries and dispose of them
separately so they may be managed correctly.
GUARANTEE CERTIFICATE
This product is guaranteed for the periods stipulated in the
Law on Guarantees. ARREGUI is liable for any non-conformities
that may occur as a result of a manufacturing fault that affects
the performance of the product within the legally prescribed
timeframe. After this period, the consumer will have to prove that
the non-conformity already existed at the time of receiving the
product.
The warranty does not cover faults caused as a result of improper
use or installation, excessive moisture or salinity, water or cement
leakage, force, unauthorised manipulation of the mechanisms,
catastrophic events, knocks or falls.
The repair or replacement of any faulty part will involve an
extension of the guarantee of the repaired or replacement part, in
accordance with the provisions of the Law on Guarantees.
The purchaser must keep the RECEIPT for the purchase of the
product to be able to accredit the date of purchase.
En