Garland 1280 QG Manuel D'instructions page 37

Fig.2
Place the security switch as shown in the diagram
over the top of the two chutes and hold in place using
the four screws.
Once in place, tighten the security screws of the chute
and exit tube (fi g 1 and fi g 2).
6.2.3. MOUNTING THE TENSION PULLEY OF THE BELT
Remove the holding seal of the cotter being careful
that it does not fall out.
Place the tension pulley as shown in the diagram and
tighten the screw.
ATTENTION: Before placing the pulley in place,
make sure that the cotter is in place.
6.2.4. MOUNTING THE TRANSPORT HANDLE AND
EMERGENCY BUTTON
Place the transport handle and tighten the two wing
nuts.
37/160
English