Magmaweld RS 350 M PRO Mode D'emploi page 34

34 Annex
ANNEX
EN
5.1 Fine Settings in the Wire Feed Unit
You can make fine adjustments through the panel above the wire feed motor.
1- Free Wire Feed Button: As long as the button is held pressed, the wire is fed and the gas valve does not
operate. You can use this button to feed the wire into the torch.
You can use this button to change the gas in the system after a gas change.
2- Free Gas Button: As long as the button is held pressed, gas flow is enabled and wire feed does not run.
USER MANUAL
RS 350 - 450 - 550 M / MW PRO
www.magmaweld.com