Magmaweld RS 350 M PRO Mode D'emploi page 11

RS 350 - 450 - 550 M / MW PRO
TECHNICAL INFORMATION
1.1 General Information
RS 350 M / MW PRO, RS 450 M / MW PRO and RS 550 M / MW PRO are 3-phase, step-voltage controlled
MIG / MAG welding machines with horizontal characteristics, aimed for use in series production and construction
and which that can weld solid and cored wires. The welding voltage can be adjusted through the panel in front
of the machine and the wire feed speed can be set from the panel in front of the wire feeder. Welding voltage and
current can be monitored via digital display. The optimum welding parameters can be selected from the table
in the front panel in the wire feed unit. A 24 V electrical socket for the integrated gas tube platform and C02 gas
heater are available. It is cooled by the fan and has protection against overheating.
1.2 Machine Components
1
2
3
4
5
6
7
1- Wire Speed Welding Current Indicator
2- Torch Connector
3- Fine (Voltage) Adjustment Switch
4- Coarse (Voltage) Setting Switch
5- Welding Current Plug Socket WF Connection 15- Gas Cylinder Fixing Chain
6- Wire Feed Unit Connector
7- Gas Outlet Connection
8- Set / Source Voltage Indicator
9- Adjustment Knob
10- Rotating Apparatus
www.magmaweld.com
8
9
10
11
12
14
Figure 1 : RS 550 M PRO Front and Back View
Technical Information
11- Handle
12- On/Off Switch
13- Ground Cable Socket (-)
14- Wheel
16- CO2 Heater Outlet
17- Gas Inlet
18- Fan Outlet
19- Gas Cylinder Transport Platform
11
EN
15
16
17
18
19
USER MANUAL