Publicité
Les langues disponibles
Les langues disponibles
BEZZERA B2013-B2016-C2013 Compact-Woody
MOD.
+32°C. In case of the machine is exposed at lower
than 0°C act in the following way:
Make sure that machine has spent at least 24h in a
place with at least +15°C before turning on.
-
The feedwater pressure must be between
0 to 6 bar (0 - 0,6 MPa). Pressure is shown by
the pump pressure gauge (Fig 11 - B) havin a 0 –
15bar range (0 – 1,5 MPa).
-
If the red control light is on (Fig. 01/01A;
pos. 15), it means that machine in on.
-
If the green control light is on (Fig.
01/01A; pos. 9), it means that the water level is
over the minimum
-
If the orange control light is on (Fig.
01/01A; pos. 8), it means that the electrical resist-
ance is on.
6.2 Cleaning of machine
Warnings: For the best results and in
compliance with current regulations,
change the water contained in the boil-
er and pipings at every daily startup of
the machine.
These advices are indicative, the maintenance and
cleaning schedules depend on the use of the ma-
chine.
After each use
1) Clean the steam nozzle.
2) Clean the filter holder and the filters.
Daily
1) Clean the cup holding grid and the drain basin.
2) Clean the body.
3) Clean the group's gasket with the brush sup-
plied (Fig. 07).
4) Wash the group as follows: hook the filter hold-
er with the blind filter supplied to the group (Fig.
09; pos 12) and initiate output for a few times.
5) Immerse the filter holder and the filters in hot
water for a few minutes to dissolve the grease of
the coffee, use a cloth or sponge to remove it.
For washing and cleaning operations,
do not use solvents, detergents or abra-
sive sponges but only specific products
for coffee machines. Wash the body us-
ing a cloth soaked in water and/or neutral deter-
gents, and dry the surfaces well prior to connect
the machine to the electric line again. Use water to
wash the cup holding grid and the drain basin.
6.3 Safety thermostat – Manual resetting
Warning! The operation de-
scribed below must be absolute-
ly performed by a technician au-
thorized by the manufacturer.
In normal operating conditions, the machine is
equipped with an anti-overheating system, by us-
ing the safety system (RESET) (Fig. 08; pos. D).
This system avoids any accidental burn, and tem-
porarily blocks every machine's function
6.4 Proper disposal of the product
(electric and electronic waste)
(Applicable in the countries of the European Un-
ion and in those with separated waste collection
system)
The label affixed on the product and on the docu-
ments indicates that the product must be disposed
with other domestic waste at the end of its life cycle.
To avoid possible damages to the environment or
health caused by improper disposal of wastes, the
user must separate this product from other types of
waste and recycle it responsibly so as to favour the
sustainable reuse of material resources.
Domestic users shall contact the reseller from
whom they purchased the product or
the envisaged local office to obtain all
information relative to the separated
waste collection and recycling of this
type of product.
Corporate users shall contact their supplier to
check the terms and conditions of the purchase
agreement.
This product must not be disposed together with
other industrial waste.
46
Publicité
