Pentair FLECK 5800 SXT Guide De L'utilisateur page 6

User Guide Fleck 5800-SXT
3.3. Description and components location
3.4. By-passing
If the system is equipped with a bypass and if a problem occurs, turn the valves to bypass the system as shown in the picture below.
Normal operation
In
4 . Programming
Note:
The controller must be plugged to be programmed.
After 5 minutes without any button pressed, the unit returns to normal operation without saving.
4.1. Basic programming
Note:
Menus are displayed in a defined and incremental order.
Day of Override
Note:
Determine the maximum number of days of operation without regeneration.
Regeneration time
A
Press and
B
Select the number of days of Override with
C
Press to validate the selection and advance to the next parameter.
Note:
Determine the time of regeneration.
D
Adjust the regeneration time with
E
Press to validate the selection and advance to the next parameter.
6 / 36
Brine
Drain
Mixing device
Outlet
Meter
Inlet
Softening System
Out
simultaneously for 5 seconds to enter the menus sequence.
and
Down button
Up button
Display
Regeneration button
In Bypass
In
and .
.
Softening System
Out
Ref. MKT-UG-004 / E - 23.09.2020