Benthaus Opal Manuel De L'utilisateur page 42

7.4 Variable installation possibilities:
Overlying installation
Dimensions in mm
4
R5
2
min.50
1
Minimum distance to adjacent walls
Opening dimensions
Cutout dimensions
Outer dimensions of the hob
Important!
There is a risk of breakage if the hob is canted or
subjected to stress during installation!
42
Instructions for assembly
4
600
560+1
2 4
min.50
1
7.5 Variable installation possibilities:
Flush installation
Dimensions in mm
604+1
3
R7
2
560+1
min.50
1
Glue the sealing tape onto the corner of the supporting
edge of the worktop so that no silicone adhesive can be
pressed under the hob.
Place the hob into the worktop cut-out without any
adhesive and align it. Use shims if necessary
Fill the gap between the hob and the worktop with heat-
resistant silicone adhesive.
Important!
Silicone adhesive must not get under the support
surface of the hob. If this occurs it will not be
possible to remove the hob again at a later stage.
No liability will be assumed in the case of failure to
observe these instructions.
ENG
3
3
2
min.50
1