Benthaus Opal Manuel De L'utilisateur page 32

Suitable for induction cooking
32
Operation
4.10 Permanent pan recognition
If the hob has permanent pan recognition, a cooking setting can
only be directly switched on via the sensor fi eld after a pan has
been detected on the hob and the power display shows 0.
4.11 Operating the keys
The controls described here expect the pressing of a (selection)
key to be followed by the pressing of a subsequent key. The next
key will need to be pressed within 10 seconds, otherwise the
selection will be deleted.
4.12 Switching on the hob and cooking zones
1. Press the ON/OFF key
level 0 appears and a short signal will sound. c.
The permanent pan recognition recognizes on which cooking
zone a pan is set up and shows a 0 in the corresponding
cooking level display.
2. Use the cooking level display (as a key) to select a cooking
zone. The stand-by dot of the cooking zone selected will light
up.
3. The touch control
afterwards. A cooking level will be switched on.
See the section on Worth knowing about the slider (sensor
fi eld)
Stand-by dot
Press the respective sensor fi eld
cooking level or to switch on an additional cooking zone.
Important: the stand-by dot of the cooking zone selected must
light up.
4. Immediately put cookware suitable for induction cooking onto
the cooking zone. The pan recognition device will activate the
induction coil. The pot or pan will be heated up.
As long as no cooking pot is placed onto the cooking zone,
the display will alternate between the cooking level set and the
symbol
off after 10 minutes for reasons of safety. Please refer to the
Section on pan recognition.
4.13 Switching off a cooking zone
Use the cooking level display (as a key) to select a cooking zone.
The stand-by dot of the cooking zone selected must light up.
5. a) Press the sensor fi eld on the far left
b) drag your fi nger to the left across the touch control
c) press the ON/OFF key
(all the cooking zones are switched off ).
4.14 Switching off the hob
6. Press the ON/OFF key
irrespective of any settings.
Please note:
The hob will switch off automatically after 10 seconds when all the
cooking zones are switched of manually (cooking level 0) and no
key/sensor fi eld is pressed afterwards.
* The Power boost function is activated immediately. See the
section on Cooking levels.
(approx. 1 sec.) until the cooking
must be activated immediately
.......left cooking level 0.
.......center cooking level 6.
.......right cooking level P*
. If no pot is placed on the cooking zone it will switch
to reduce the cooking level to 0
. The entire hob will be switched off
. The hob will be switched off ,
ENG
to change a
or