Klarstein Olivia Mode D'emploi page 20

EN
20
All manuals and user guides at all-guides.com
TROUBLESHOOTING
Problem
Pressing shaft get stuck.
Motor stop working
without oil coming out
motor working without oil coming out A cavity protection cover has not
Motor stops by accident.
Hopper set at the wrong position
Cavity lock buckle cannot
be set to right position
Light Codes
Guiding light reference
Quick flashing red light
Possible Solution
A Press"reverse" button for
5-10seconds ,then press "pause/
start" button to work again
B Pull off the plug, Dismantle the
cavity and pressing shaft, clean out
the left residue from hopper and
feeding hole, then assemble
to restart again
.
A:it needs 30 seconds for machine to
be pre-heated. B Check if hopper and
hopper lid set rightly.(hopper can be set
rightly only if cavity lock buckle on the
right position.)
rotated to the right position
A: check if the hopper without material
over 1 minute, please press
" pause/start" button to restart
again if in protection proceed.
B: It would be in protection proceed
if keep working over 45 minutes
C: Check if big size material in the
hopper got stuck over one minute,
it would be in protection proceed
with this case. please restart the
machine, mix material with Muddle.
D: Check if hopper or hopper
cover in the right position.
A Check if cavity lock buckle
in the right position.
A Set the pressing shaft in the
hexagon hole first then the cavity.
Machine status
Pre-heating