Publicité
Les langues disponibles
Les langues disponibles
Model DSC
BACKLIGHT OPERATION
1. Two backlight modes are available here: "No backlight" mode and "auto-backlight" mode. The "No backlight" will never show the
backlight under any condition. The "auto-backlight" mode will light up the backlight when any key is pressed or when the weight on
the scale is more than 5d. Five seconds later, the light will extinguish after the weight comes to "0".
2. Under the mode of weight measuring, you will enter into the other backlight mode by keeping pressing
mode, the scale will automatically keep the backlight mode set previously when you turn the scale on again.
CHARGE THE BATTERY
When the under voltage indicator is glittering, it shows the insufficient power and you need to recharge it in time. Connect to the power
supply to make the AC indicator light up. This stands for it's charging now. The average charging time is 12 hours.
ELECTRIC QUANTITY INDICATION
1. When the under voltage glitters, it shows the insufficient power and need recharging in time.
2. If the display screen does not show or shows "Lo",this means The battery is in the self-protection state, and you should charge it in
time and then you can use it.
7. MENU SET
Press and hold
before turning the scale on. The UNIT WEIGHT screen shows the information and the WEIGHT screen shows the
value. After all the set is over, it will automatically back out from the menu set and back to the weighing and counting mode. Press
for change the value and press
Specific set as follows:
Nº de serie
1
Zero tracing
2
Zero range
3
Dynamatic examination
4
Warning internal and external
5
Average filter
6
Calibration mode
7
Sample speed
8
9
Auto-averaging
10
11
Zero memory
All manuals and user guides at all-guides.com
Counting scale
for go to next menu.
Pantalla
Valor programa
0d
1d
Zero
2d
3d
0d
1d
Zrage
2d
3d
0d
1d
D-rng
2d
3d
Pass
limit
Point
16
Spnt
Speed
Filt
filter
Aver
A-Salt
Alarm
OLoad
Programa de introducción
0 stands fro no tracing.
1 stands for tracing 1d
The bigger tracing vlue, the quicker back to zero
Quand plus grand est la valeur programmée, plus rapidement
retournera à zéro.
The bigger dynamic value is, the more stable is. But the re-
solution is worse and it's suitable to be used in a worse en-
viroment.
0
0 stands for the warning internal limit presetting
1
1 stands for the warning external limit presetting
4
The bigger the filter point is, the more stable the scale is. But
8
the reaction speed is lower.
0
Multipoints calibration not allowed
1
Multipoints calibration mode allowed
0
Factory set
1
Fast sampling
0
1
2
3
0
Allow auto-averaging
1
Forbid auto-averaging
0
For counting
1
For weighing
0
Zero desviation correction
1
No zero desviation correction (zero memory ON)
User's Guide
key. After setting the
17
Publicité
