Cleaning And Maintenance; Troubleshooting; Technical Specifications - Skandika V 2000 Instructions De Montage Et Mode D'emploi

Cleaning and maintenance

• Before cleaning the appliance, make sure that the appliance is switched off and the
plug is disconnected. Allow the unit to cool down.
• Clean the device with a slightly damp cloth only. Never use brushes, aggressive cleaning
agents, petrol, thinners or alcohol. Rub the seat dry with a clean dry cloth.
• Never immerse the appliance in water to clean it and ensure water cannot get into
the appliance.
• Wait until the device is completely dry before using it again.
• Take care when rolling up the mains lead to avoid damaging it.
• You should ideally store the device in its original packaging and keep it in a clean, dry
place.

Troubleshooting

• Device cannot be started
Check plug (power connection) and if power switch is switched on.
• Remote controller does not work
Replace batteries (2 x AAA batteries are necessary) and check, if the distance bet-
ween remote controller and device is less than 2.5 meters.
• Sudden stop
Default working time of 10 minutes is over. Please re-start the device after a pause of
at least 10 minutes.
• Display „ER01" or „ER02" or showing abnormal behaviour
Disconnect the power supply, wait for 2 minutes and re-start the device.
If the problem cannot solved with above hints, contact the customer service.

Technical specifications

Max. user weight: 125 kg
Frequency: 50/60 Hz
Rated power: 200 W + 80 W = 280 W
Integrated speaker: 3 W
Oscillation amplitude: 11 mm
Oscillation frequency: 7-12 Hz
Vibration amplitude: 1 mm
Vibration frequency: 22-35 Hz
26