Publicité
Les langues disponibles
Les langues disponibles
12.4.4 Mounting the suction kit
Suction valve
12.4.5 Mounting the pH and/ or ORP probes
Probes are delicate. They must be regularly maintained and calibrated using the buffer solutions
provided with the device. In the event of a fault, there is a risk that excess chemical could be
Remove the probe from its
protective sleeve and undo the
probe housing nut.
If the probes are mounted on a by-pass loop, make sure that the shut off valves are open
TRAITEMENT DE L'EAU
PVC tubing
(transparent)
WARNING
injected and that water quality could be degraded.
Slide the nut onto the probe,
making sure that the seal is in
place underneath, then insert the
probe.
WARNING
while the device is in operation.
32
Tighten the nut onto the
Serrer l'écrou sur la
dosing pump.
pompe doseuse.
Hand tighten the probe housing
nut. The probe is ready!
2023/04 - Indice de révision : A - Code : 29600
Place the weighted valve in the
Poser le clapet lesté de fond de
bottom of the tank and adjust the
bac et ajuster la profondeur.
depth.
Publicité
