Publicité
Les langues disponibles
Les langues disponibles
The probe saddle clamps may be installed on a by-pass circuit so that they may be hydraulically isolated
to allow faster and simpler dismantling and in order to allow filtration to continue to run (notably during
active winterizing).
Mounting the pipe saddle clamps
12.4.1
Place the clamp halves on
either side of the pipe on a
straight section at least
15 cm long
12.4.2 Mounting the probe housing assembly
Teflon tape
Placement of the
probes
Ideally, the probe
should be mounted
vertically over the pipe
TRAITEMENT DE L'EAU
Screw
Seal
Nut
Tighten both sides at the
same time to keep the
clamp straight
Probe housing
Water pressure should not exceed 1.5 bar
The tilt angle of the
probe should never
exceed 45° as
measured from vertical
30
Once the clamp is
mounted, drill a 16 mm
hole in the centre
2023/04 - Indice de révision : A - Code : 29600
Publicité
