Publicité
Les langues disponibles
Les langues disponibles
12. Installation and connections
BWT EASY DOSE equipment should only be installed and connected by properly qualified
persons. It must be installed in accordance with the safety regulations in effect in the country
mètres (volume 2 ci-dessous).
Always cut the primary power supply before energising the device or manipulating the
outputs. Never open the device while it is energised! Interventions for maintenance and
repair should only be carried out by trained and accredited personnel.
12.1 Selecting the installation site
To ensure the safety of users and correct operation of your BWT EASY DOSE please respect
the following installation instructions:
The control panel must be located at a distance from the pool that complies with the regulations
in effect in the country of installation.
The device must be protected against rain and splashing, freezing and direct sunlight.
The ambient temperature must be between 0 and 50°C.
Humidity must not be at saturation.
The installation site must be properly ventilated, to prevent the creation of a corrosive
atmosphere or an atmosphere saturated with solvent fumes.
Choose a location not subject to vibrations, the support surface must be stable and solid, clean
and perfectly flat.
In the event that these instructions are not followed:
The device could be damaged
Measurements may be falsified
The guarantee may be void!
12.2 Installation on the wall mounted bracket
TRAITEMENT DE L'EAU
CAUTION
of installation!!
CAUTION
27
2023/04 - Indice de révision : A - Code : 29600
Publicité
