Abus TVIP71500 Manuel Utilisateur page 116

Wireless (TVIP71550 only)
The camera is equipped with a WLAN network interface for transmitting data wirelessly in an IP network. The
network camera must be connected via a network cable for the initial configuration of all WLAN parameters.
Wireless:
Status of wireless networks: The camera searches the area automatically for WLAN access points (AP).
ESSID:
Mode:
Security:
Channel:
Signal strength:
Bit rate:
MAC address:
IP address:
ESSID:
Manual setting:
Mode:
Managed:
Ad-Hoc:
Authentication:
Open
WEP
WPA-PSK / WPA2-PSK
Encryption:
Key length:
Active transmit key:
Obtain an IP address automatically (DHCP):
Use the following IP address:
Use the following DNS server address:
Activates or deactivates the WLAN interface.
The connected access point is displayed in blue.
(See below).
(See below).
Specifies the security method for this network.
Shows on which channel the access point is transmitted.
Display of the signal quality (in %). To ensure a good connection, this value
should not be below 60%.
Shows the gross bit rate of the access point.
The MAC address (network device address) is determined automatically and
displayed here.
The set IP address is displayed here. The address can be assigned
automatically (DHCP) or manually (see below).
ESSID is the name of the access point. This can be determined automatically
or entered manually.
Indicates manual setting of the ESSID.
Select the WLAN connection mode here.
The network camera is connected to the network via an access point.
In this mode, the network camera can communicate directly with another
network adapter (network card). A peer-to-peer environment is established.
The encryption mode for wireless transmission can be set here.
No encryption selected.
(Wired Equivalent Privacy) A 64 or 128 bit key is used for encryption (HEX or
ASCII). These keys must be the same on both devices in order to
communicate with other equipment.
(10/26 HEX characters or 5/13 ASCII characters according to bit length)
(Wi-fi Protected Access – Pre-Shared Key) In this method, dynamic keys are
used. TKIP (Temporal Key Integrity Protocol) or AES (Advanced Encryption
Standard) can be selected as the encryption protocols. A Pre-Shared Key
must be assigned here.
(64 HEX characters or 8 to 63 ASCII characters)
Select the corresponding encryption type here.
WEP / deactivated
WPA-PSK / WPA2-PSK: TKIP or AES
WEP only. Select the bit length for the key here.
WEP only. Up to four keys can be assigned.
The IP address, subnet mask and address for the default
gateway are obtained automatically from a DHCP server.
An activated DHCP server must be present in the network
in this case.
Manual setting of the IP address, subnet mask and default
gateway.
If the DNS server address is not assigned automatically by
a DHCP server, then it can be entered here manually.
121