Publicité
Les langues disponibles
Les langues disponibles
2.
Mount the cutter blade onto the receive washer
so that the arrows on the cutter blade and protector are
pointing in the same direction.
1
► 1. Arrow
For the chisel and shredder blade, mount them as
illustrated.
Chisel blade
Shredder blade
3.
Put the clamp washer onto the cutter blade and
then tighten the nut securely by the box wrench.
1
► 1. Box wrench 2. Hex wrench 3. Loosen 4. Tighten
NOTE: Tightening torque : 20 - 30 N•m
4.
Remove the hex wrench from the gear case.
To remove the cutter blade, follow the installation proce-
dures in reverse.
Nylon cutting head
NOTICE:
cutting head.
► 1. Nylon cutting head 2. Spindle 3. Hex wrench
4. Loosen 5. Tighten
1.
Insert the hex wrench through the hole in the gear
case to lock the spindle. Rotate the spindle until the hex
wrench is fully inserted.
2.
Place the nylon cutting head onto the spindle and
tighten it securely by hand.
3.
Remove the hex wrench from the gear case.
To remove the nylon cutting head, follow the installation
procedures in reverse.
15 ENGLISH
4
1
3
Be sure to use genuine Makita nylon
4
5
2
2
1
3
Publicité
