Publicité
Les langues disponibles
Les langues disponibles
To remove the protector extension from the protector,
unclasp the clips by inserting the hex wrench as illustrated.
► 1. Hex wrench 2. Clip
For chisel blade
Optional accessory
Align the protrusion on the gear case with the groove on the
protector, and then attach the protector to the clamp using bolts.
2
► 1. Clamp 2. Protector 3. Protrusion 4. Groove
For shredder blade
Optional accessory
Attach the protector to the clamp using bolts.
2
► 1. Clamp 2. Protector
Installing the cutting tool
CAUTION:
to remove or to install the cutting tool.
CAUTION:
1
inserted into the gear case after installing the
cutting tool.
NOTE: The type of the cutting tool(s) supplied as
the standard accessory varies depending on the
countries. The cutting tool is not included in some
countries.
2
NOTE: Turn the tool upside down so that you can
replace the cutting tool easily.
Cutter blade / chisel blade / shredder
blade
CAUTION:
always wear gloves and put the blade cover on
the blade.
CAUTION:
ished, and free of cracks or breakage. If the cutter
blade hits a stone during operation, stop the tool and
1
check the cutter blade immediately.
CAUTION:
blade must be as follows. Never use any cutter
blade with larger outside diameter.
—
—
—
3
—
—
4
—
1
► 1. Nut 2. Clamp washer 3. Cutter blade 4. Spindle
5. Receive washer 6. Hex wrench
1.
case to lock the spindle. Rotate the spindle until the hex
wrench is fully inserted.
14 ENGLISH
Always use the supplied wrenches
Be sure to remove the hex wrench
When handling a cutter blade,
The cutter blade must be well pol-
The outside diameter of the cutter
2-tooth blade : 305 mm (12")
3-tooth blade : 305 mm (12")
4-tooth blade : 255 mm (10")
8-tooth blade : 255 mm (10")
Chisel blade : 225 mm (8-7/8")
Shredder blade : 270 mm (10-5/8")
4
5
Insert the hex wrench through the hole in the gear
1
2
3
6
Publicité
