Scheppach HC51V Traduction Des Instructions D'origine page 21

1. Introduction
Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer
We hope your new tool brings you much enjoyment and
success.
Note:
In accordance with the applicable product liability laws,
the manufacturer of this device assumes no liability for
damage to the device or caused by the device arising
from:
• Improper handling,
• Non-compliance with the operating manual,
• Repairs carried out by third parties, unauthorised
specialists.
• Installing and replacing non-original spare parts
• Application other than specified
• Failure of the electrical system in the event of the
electrical regulations and VDE provisions 0100,
DIN 13 / VDE0113 not being observed
Please consider:
Read through the complete text in the operating manu-
al before installing and commissioning the device.
The operating manual is intended to help the user to
become familiar with the machine and take advantage
of its application possibilities in accordance with the
recommendations.
The operating manual includes important instructions
for safe, proper and economic operation of the device,
for avoiding danger, for minimising repair costs and
downtimes, and for increasing the reliability and ex-
tending the service life of the device.
In addition to the safety instructions in this operating
manual, you must also observe the regulations appli-
cable to the operation of the device in your country.
Keep the operating manual package with the machine
at all times and store it in a plastic cover to protect it
from dirt and moisture. They must be read and careful-
ly observed by all operating personnel before starting
the work.
The device may only be used by personnel who have
been trained to use it and who have been instructed
with respect to the associated hazards.
The required minimum age must be observed.
In addition to the safety instructions in this operating
manual and the separate regulations of your country,
the generally recognised technical rules relating to the
operation of such machines must also be observed.
We accept no liability for accidents or damage that
occur due to a failure to observe this manual and the
safety instructions.
2. Device description (Fig. 1)
1. Transport handle
2. Quick coupling
3. Pressure vessel
4. Supporting foot
5. Wheel
6. Pressure regulator
7. Manometer
8. Safety valve
9. On/off switch
10. Drain screw for condensate
A. Nut
B. Washer
C. Hexagon screw
D. Wheel bolt
3. Scope of delivery
1x compressor
2x feet (4)
2x wheels (5)
2x nuts (A)
2x washers (B)
2x Hexagon screw (C)
2x wheel bolt (D)
Operating manual
4. Proper use
The compressor is used to generate compressed air
for pneumatically powered tools that can be operated
with an air rate of up to 109 l/min. (e.g. tyre inflaters, air
blow guns, paint spray guns).
Due to the limited air flow rate, it is not possible to op-
erate tools with a very high compressed air consump-
tion (e.g. orbital sanders, straight grinders and impact
screwdriver).
www.scheppach.com GB | 21