Starting The Hydromassage - Teuco HYDROLINE Hydrosilence T50 Manuel De L'utilisateur

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

STARTING THE HYDROMASSAGE

- When in standby mode, the panel is lit at low
intensity.
- To start the hydromassage function, press the
HYDRO key.
- The reception of the "Hydro ON" command
is confirmed by the high frequency flashing
of the HYDRO key. After a few seconds, the
hydromassage switches ON in cyclic mode by
default, with the regulation of the hydromassage
that varies from Max to Min.
- The HYDRO key illuminates at high intensity
and the SANIFICATION key flashes at low
frequency from low intensity to high intensity.
- After
30
minutes,
automatically stops.
- To stop the hydromassage, press the HYDRO
key again.
- The panel will return to standby mode.
- When the HYDRO key flashes at low frequency
between OFF and high intensity indicates
an insufficient level of water in the tub. The
hydromassage does not function until there is a
sufficient level of water.
Never start the hydromassage function if the water in the tub does not cover the level of the jets.
During hydromassage operation, it is possible to use the botanical cosmetic products made by
Teuco. Do not use soaps, bath oils or foaming products.
HYDROLINE
the
hydromassage
EN
30min.
9

Publicité

Table des Matières
loading

Table des Matières