Publicité
Les langues disponibles
Les langues disponibles
The blade does not stay on the motor
shaft?
The dough made has not absorbed all
the ingredients?
A ball of dough forms on top of the
blade and the dough is not kneaded
evenly?
The dough remains hard after being
kneaded?
The dough is too dry?
The dough is too wet?
The lid opens at the back and/or makes
a lot of noise?
The motor slows when it is processing?
It is difficult to remove the chopping/
mixing blade from the bowl?
The processor vibrates/moves while it
is running?
The large pusher falls when the bowl is
turned?
36
All manuals and user guides at all-guides.com
It is possible that the blade was not properly attached before starting the appliance.
A dough that is too sticky might also cause this to happen. If this is the case, reattach
the blade and immediately add 2 tablespoons of flour through the feed tube while the
machine is running.
It is possible that the amount of dough exceeds the maximum recommended amount of
your processor. Remove half the dough and process in batches.
The dough may be too dry.
It is also possible that the dough is too wet.
Stop the machine, gently remove the dough. Divide the dough into three parts and
distribute these pieces evenly in the bowl.
Divide the dough into 2 or 3 portions and distribute these evenly in the bowl. Process
the dough for 10 seconds or until it is uniformly pliable and can be perfectly folded.
While the machine is running, add some water (1 tablespoon at a time) until the dough
has absorbed all the ingredients in the bowl
While the machine is running, add some flour (1 tablespoon at a time) until the dough
has absorbed all the ingredients in the bowl.
The lid opening at the back and the noise that could result does not prevent the
appliance from working. Simply close the lid again to lock it in place.
It is possible that the maximum recommended quantity has been exceeded. Remove
some of the ingredients and continue processing.
The blades have been designed to be locked into the bowl and not come loose when
emptying the bowl. Being careful not to injure yourself, gently force the blade loose by
pulling on it.
Make sure that the rubber strip on the base of the appliance is clean and dry. Make sure
that the maximum recommended quantity has not been exceeded.
The pusher locking mechanism (located above the handle) should be engaged.
Publicité
