Publicité
Les langues disponibles
Les langues disponibles
EN
7. Lifting arm assembly (optional)
A. Align the cross bar with left and right support parts, insert them
and push them into place, fix them with 4mm*16mm screws.
cross bar
support parts
B. Remove two screws and nuts on shovel bucket, align the
bucket with two support parts, insert the screws and nuts on both
sides.
cross bar
support parts
screw
nut
14
C. Shovel bucket handle assembly
Remove the nuts and handle grip from the iron bar, align one end
of the iron bar to the hole on shovel bucket, fix with the M6 lock
nut.
Align another end of the iron bar to lifting arm, fix the handle grip
and M6 lock nut from outside of the lifting arm.
M6 lock nut
handle grip
M6 lock nut
8. Lifting arm sets assembly (Optional)
plastic cover
There are two plastic covers on both sides of the car body, remove
the covers, you can see a hole on car body. Remove the nuts and
the bushings from lifting arm axle, insert the liting arm axle through
this hole.
lron bar
lifting arm
axle
15
EN
Publicité
