Publicité
Les langues disponibles
Les langues disponibles
EN
11. Car body connector assembly (Optional)
This assembly step is optional, it suits for the specification with
excavator or trailer. Release the screw of connector on car body,
remove the original connector and take out new connector from
accessory kit,replace with new connector and fix with same screw.
Attach rear support part under car body and fix with two screws.
rear
support
part
connector
12. The connection of trailer and car body (Optional)
Attach the trailer with the connector on car body and insert the
plastic lock.
plastic
lock
18
13. Digging bucket assembly (Optional)
Attach the digging bucket with the connector on car and fix it.
FUSE
This car has an auto-reset fuse, if the car stops suddenly during
driving, it is mainly caused by instantaneous current exceeds ,
which makes the fuse to trip. Then just stop operating for about 8
seconds, and this fuse can be reset. Then turn on the power switch
again. In order to avoid the fuse tripping and cutting off power
supply, please pay attention to the following matters.
This product can't be overloaded, the maximum load is 30kg
(66lbs).
Don't drag anything behind the product.
Don't let the water or other liquid goes into the batteries and other
electrical components.
Don't change the circuit system and structure of the product.
19
EN
Publicité
