Publicité
Les langues disponibles
Les langues disponibles
EN
1. Battery connection
Connect two red plugs of red wires under the seat.
2. Driving connecting
part assembly
Attach the driving
connecting part with
the wheel and secure
with three screws.
3. Front wheel assembly
A.Remove the nut and small washer from front axle with sleeve
tool.
There's no need to remove the big washer.
B.Insert the front wheel and small washer to front axle, fix the nut
with sleeve tool. Then install the wheel cover.
Big washer
Driving
connecting
part
Screw
Small washer
Nut
12
4. Rear wheel assembly
A. Remove the nut and washer from rear axle with the sleeve tool.
Insert the rear axle to the car body, make sure the axle lengths
that extend out on both sides are same.
B. Insert the motor to the rear axle, connect the plugs of motor
and car body. Two motors are different, please distinguish between
left and right.
C. Insert the rear wheel and washer to rear axle. Fix the nuts on
both sides with sleeve tool at the same time.
A
C
5. Steering wheel assembly
Insert the steering wheel to
steering column on car body, press
two pins on steering column, the
pins will pop up after installation.
Motor
B
Washer
Nut
6. Seat assembly
Insert the seat with car body
and push it into place.
13
EN
Publicité
