Tools - LEMAN RAD250 Manuel D'utilisation

wear short strengthened apron and safety goggles. It is suitable to use adequate protection of
hearing and recommended working footwear. It is forbidden to use working mantle.
Workers qualification
Only authorized worker specialized in woodworking branches (or worker instructed by this
specialist) is allowed to work with the machine. Operators are liable to abide with all safety
instruction and regulations, which are valid in his country.

TOOLS

Recommended tools
Cutterblocks have to be marked with manufactures name or logo (marking) and max allowed
rotations. Suitable tools for this machine are knives system HSS 250X30X3mm and must meet
the reqirements of EN847-1.
Exchange and adjustment of knives
WARNING! Disconnect the machine from mains before any adjustment.
Swing away the planing tables before exchange of knives.
Release five screws (4) by spanner.
By the force of the spring (1), the knife (2) will be pushed out automatically.
Remove the knife and clean the bearing surface.
Clean the new knife carefully.
Insert the new knife by screwing five screws (4) so that its extension above the surface of
cutterblock in max 1.1mm.
１２
EN