LEMAN RAD250 Manuel D'utilisation page 77

Planing of narrow workpieces
When planing narrow pieces, set the cover of the cutterblock in such a position so that the
distance between the workpiece and the cutterblock cover is max 5mm. Then switch on the
machine and push the material against the cutterblock (between the cutterblock cover and the
rule).
Planing with the inclined ruler
0
Check the angle of the longitutinal ruler when the small cranks are loosen (the position 90 is
ensured), retighten the small cranks again and switch on the machine. Push the edge of the
workpiece forward and against the rule.
Planing of short workpieces
９
EN