Repairs; Parts Diagram - LEMAN RAD250 Manuel D'utilisation

REPAIRS

Any defect should not arise if you are operating the machine in the right way and making the
suitable maintenance regularly. In case that the sawdust sticks on the cutterblock or the
exhausting hose is filled up, switch off the electric motor before you start any repairs, otherwise
it could be damaged. Also switch off the electric motor immediately, if the workpiece is getting
jammed.
Exchange them immediately in such a case. If the machine embodies increase vibrations, check
its placing, fixing or balance of tools.
The machine do not work.
Check the electrical installation and connection to the mains.
The thicknessing table moves only with difficulties.
Loosen the clamping lever of the table.
The output of the machine is insufficient.
Knives are blunt.
Too thick chip is adjusted and the operator has to adjust it according to the width and hardness
of the wood.
The thicknessing table is not clean.
The V-belt of the cutterblock is not tightened well.
The electric motor has no sufficient output, it is necessary to call qualified electricians.
The machine vibrates
Knives are blunt or incorrectly adjusted.
Knives have no the same width.
The machine was installed on uneven surface.
Thicknessing is not possible on the machine
Too thick chip was adjusted.
The thicknessing table is not clean.
The working piece slaps against the back table.
Incorrectly adjustment of knives or back table.
Projection at the end to the workpiece.
Uneven surface for planing.
Incorrectly adjusted knives or tables.
Incorrect pushing or leading of the working piece while planing.

PARTS DIAGRAM:

１４
EN