Recommendations; Reception Handling - LEMAN RAD250 Manuel D'utilisation

RECOMMENDATIONS

No one must work on a wood machine without first receiving sufficient training concerning the
type of work and without being informed of the risks, the precautions to observe and operating
instructions for the guards and compulsory safety devices.
This machine is designed for wood derivatives. It should not be used for other materials.
- Before use we recommend that you carefully read through this manual and that you respect
all instructions contained in it in order to achieve the best results from your machine and to
work in complete safety.
- In order to ensure that all safety measures taken into consideration during the design of this
machine are met any modification of the machine by the user is forbidden.
Connection to a sawdust or chipping suction aspirator is obligatory to satisfy all the
-
hygiene/safety conditions and to ensure the correct operation of this machine.
You are strongly recommended to wear protective glasses while using this machine.
-
Residual risk
-
As with all wood-working machines with manual adjusting, there is always a risk, even when
guards are in place and correctly adjusted, of getting close to tools at a working height which
corresponds to the thickness of the wood.
It is essential, therefore, that hands are kept well away from the dangerous areas and that
the end of pass thruster is used.

RECEPTION HANDLING

The machine is delivered fully assembled. When handling with the machine use the certified
lifting equipment and safe instruments. The best handling can be done with transport pallet and
high lift truck. For lifting the operator can use steel wire rope seal with min diameter 5mm.
Before placing the machine on working place, the operator has to consider how large pieces of
material, which can be cut in the given room.
Safe work with the machine requires enough space around the machine. When you are sure
that the placing responds with your idea, flush the machine with max clearance 1mm/1000mm
and screw it on the floor. In any cases the operator has to level (flush) the machine in the right
way by help of four adjusting screws (placed in adjustable legs). Do not assemble parts (which
were disassembled) before the operator has read the whole instruction manuals and has known
the machine well.
Put the lengthwise rule on the guide way and adjust the length stop and secure. Clamp the
sliding table on the bars (guide way) or the support of the run-out arm and secure with the small
hand crank. Put the angular rule on the sliding table and secure.
Enclosed the operator will find the instruction manual and wrenches necessary.
Check the condition of the machine and the number of packages mentioned on the delivery
note. If necessary, make the usual reverse to the carrier.
WARNING! If reverse are made they must be made on receipt of the goods. Late claims will not
be considered.
For delivery, the machine is mounted on the wooden crate with wood blocking on the bottom of
the crate.
３
EN