Grohe F-DIGITAL DELUXE 36 371 Instructions D'installation page 9

Obstructions
For operation under adverse environments, in buildings /
rooms with reinforced concrete walls, steel and iron frame, or
near of obstructions (eg furniture) of metal, the Bluetooth
reception can be disturbed and interrupted.
Type of obstructions
Wood
Synthetic material
Glass
Water
Bricks
Marble
Plaster
Concrete
Bulletproof glass
Metal
Fault Cause
Pairing not possible • PIN entry is not correct
• Another device is already connected
• No reception/connection interrupted
• Interferences in the reception area
• Obstacle in transmission path
Connection not • Another device is already connected
possible
• No reception/connection interrupted
• Interferences in the reception area
• Obstacle in transmission path
®
• Device out of receiving range
adaptor
Bluetooth
does not appear in
• There is already a connection to a device
®
list of
Bluetooth
• Bluetooth
device
• Failure at Bluetooth
Interrupted while • Interferences in the reception area
operating
• Obstacle in transmission path
® • Bypass removed without external
adaptor
Bluetooth
without function
Disposal instructions
This category of device does not belong in the
domestic waste, but must be disposed of
separately in accordance with the relevant local
national regulations.
Dispose of batteries in accordance with national
regulations.
All manuals and user guides at all-guides.com
Interference or shielding potential
Low
Medium
High
Very high
®
adaptor not supplied with
voltage
®
adaptor
interface connected
Radio Frequency reflective and absorbing
RF components using the same frequency band of 2.4GHz
(eg wireless devices, phones, etc.) may affect the quality of
reception (observe the manufacturer´s documentation!).
.
Remedy
- Check PIN on the Bluetooth
- Disconnect and perform pairing again
- Turn back the device to receiving range
- Turn off the source of interference
(observe manufacturer´s documentation)
- Remove from radio path
- Disconnect and perform pairing again
- Turn back the device to receiving range
- Turn off the source of interference
(observe manufacturer´s documentation)
- Remove from radio path
- Device back to receiving range
- Disconnect the device, then connect again
- Check the installation
- Start reboot
- Turn off the source of interference
(observe manufacturer´s documentation)
- Remove from radio path
- Put in bridging contact (C), see fold-out page I.
®
adaptor (sticker)
6