Grohe F-DIGITAL DELUXE 36 371 Instructions D'installation page 89

External interface
Via the external interface the Bluetooth
rebooted or resetted. It is adapted as a break contact, which
can be used with conventional nc (normally closed) type
switches or push buttons.
1. Turn the entire system free of voltage.
2. Remove Bypass (C), see fold-out page I.
3. Connect switch or push button with cable 47 868 000
(special accessorie) to the external interface
(max. 16.4 ft [5m]).
4. Supply the entire system with voltage.
If the external interface is not used, the bridging contact
must remain plugged in!
Pairing
Pairing means the first coupling between two Bluetooth
devices. This requires a proper executed installation. For an
®
already active Bluetooth connection between a terminal
®
device and the Bluetooth adapter no pairing is possible.
®
1. Activate Bluetooth on device.
2. Select xxx Grohe SPA from Bluetooth
Operation of the reset button (A) and Visualization by status LED (B)
Function
Operation takes place
Reboot of the adapter
Reset of the adapter
Ready for operation
Modul is supplied with voltage
Permanent press of button, or
bridging contact removed
Functions
Function
Changing the device
Prioritization of connections
®
Visibility of the Bluetooth
®
Reboot the Bluetooth adapter
(Entire system turns off)
®
Reset of the Bluetooth adapter
(Entire system turns off)
Data transfer
Audio stream
All manuals and user guides at all-guides.com
®
adapter can be
®
®
list.
Visualization
LED lights permanently blue
LED lights up red for 3 sec.
LED lights up red, off, red, blue, red
LED off
LED lights up red for 1 sec.
LED flashes red
Describtion
Device will be logged out (connection closed/inactive).
After 10sec. the new device can be logged in.
It will be ensured that the operation can take place only with a single device
at any time.
The Bluetooth® adapter is always visible.
adapter
Press the button shortly (less than 3 sec.):
- Connection will be interrupted
- Bluetooth
- System shuts down (Music, light (max. 60sec. delay), steam)
Press and hold the button (between 10 and 20sec.):
- Connection will be interrupted
- Pairing list will be cleared
- Bluetooth
- System shuts down (Music, light (max. 60sec. delay), steam)
As soon as a device is connected, the system can be operated using the
Grohe App.
As soon as a device is connected, an audio stream can be sent to the
system by the Grohe App.
xxxx is the 4-digit number (PIN number) which will be
displayed.
3. Enter PIN number and confirm.
4. Connection will established automatically.
5. The LED (A) on the adapter flashes 1x blue for a short time
when connection is quite correct.
The PIN number is unique for each adapter and is additionally
documented with a sticker on the backside. These are the last
four digits of the serial number. The PIN number can not be
changed!
XXXX
When successfully paired, the PIN is no longer required when
a new connection attempt. When connected and activated the
App LED on the adapter lights up blue continuously. A
maximum of 8 devices can be paired. When logging a 9th
device the most rarely used one will be deleted from the list.
B
C
A
®
adapter reboots
®
adapter reboots
86