Grohe F-DIGITAL DELUXE 36 371 Instructions D'installation page 8

Pairing
Pairing means the first coupling between two Bluetooth
devices. This requires a proper executed installation. For an
®
already active Bluetooth connection between a terminal
®
device and the Bluetooth adaptor no pairing is possible.
®
1. Activate Bluetooth on device.
2. Select xxx Grohe SPA from Bluetooth
xxxx is the 4-digit number (PIN number) which will be
displayed.
3. Enter PIN number and confirm.
4. Connection will established automatically.
5. The LED (A) on the adaptor flashes 1x blue for a short time
when connection is quite correct.
Operation of the reset button (A)
Function
Operation takes place
Reboot of the adaptor
Reset of the adaptor
Ready for operation
Modul is supplied with voltage
Permanent press of button, or
bridging contact removed
Functions
Function
Changing the device
Prioritization of connections
®
Visibility of the Bluetooth
®
Reboot the Bluetooth adaptor
(Entire system turns off)
®
Reset of the Bluetooth adaptor
(Entire system turns off)
Data transfer
Audio stream
5
All manuals and user guides at all-guides.com
®
®
list.
and Visualization by status LED (B)
Visualization
LED lights permanently blue
LED lights up red for 3 sec.
LED lights up red, off, red, blue, red
LED off
LED lights up red for 1 sec.
LED flashes red
Describtion
Device will be logged out (connection closed/inactive).
After 10sec. the new device can be logged in.
It will be ensured that the operation can take place only with a single device
at any time.
The Bluetooth® adaptor is always visible.
adaptor
Press the button shortly (less than 3 sec.):
- Connection will be interrupted
- Bluetooth
- System shuts down (Music, light (max. 60sec. delay), steam)
Press and hold the button (between 10 and 20sec.):
- Connection will be interrupted
- Pairing list will be cleared
- Bluetooth
- System shuts down (Music, light (max. 60sec. delay), steam)
As soon as a device is connected, the system can be operated using the
Grohe App.
As soon as a device is connected, an audio stream can be sent to the
system by the Grohe App.
The PIN number is unique for each adaptor and is additionally
documented with a sticker on the backside. These are the last
four digits of the serial number. The PIN number can not be
changed!
XXXX
When successfully paired, the PIN is no longer required when
a new connection attempt. When connected and activated the
App LED on the adaptor lights up blue continuously. A
maximum of 8 devices can be paired. When logging a 9th
device the most rarely used one will be deleted from the list.
B
C
A
®
adaptor reboots
®
adaptor reboots