Bose ControlSpace AMS-8 Notice D'installation page 15

3.6 CS-WC connections and settings
4
1. Termination jumper, see NOTE in chapter 3.5
2. RS485 connector
3. Power supply connector (12-24Vdc)
4. Firmware update connector
NOTE: See Annex B. Wallpanel mounting instructions
3.7 CS-LIM connections and settings
3
1. The CS-LIM is equipped with a microphone gain adjuster, also accessible from the frontpanel by using a '0'
2. To change the CS-LIM from stereo to mono, this jumper needs to be set. In a mono configuration,
3. To activate a voice EQ (optimized EQ for speech) for the microphone input,
4. Stereo, balanced line output connector.
5. Power supply connector (24Vdc).
NOTE: See Annex B. Wallpanel mounting instructions
All manuals and user guides at all-guides.com
screw driver. Turn the adjuster anti-clockwise (seen from the front) to decrease the gain to a minimum of
32dB. Turn the adjuster clockwise to increase the gain to a max of 66dB. The factory gain setting is 38dB.
the audio cable should be connected to the LEFT output (jumper is left open).
the jumper needs to be moved from FLAT to VOICE
voice voice
= flat response
flat flat
1 2 3
2 5 4
= voice EQ
3. System Installation
1
15