Güde GAK 1001 B Traduction Du Mode D'emploi D'origine page 37

Inspection and maintenance plan
Generally
Before any start-up
After every take out of
service
storage
Failure removal
Defect
The motor does not start
Engine does not give
max. output
Complete saw
Plastic body
Saw chain
Chain saw bar
Chain saw wheel
Clutch
Saw chain
Chain saw bar
Chain lubrication
Follow-up brake
ON/OFF switch
Oil tank cap
Chain saw bar
Bar fixture
Chain oil tank
Saw chain / Chain saw bar
Complete saw
Cause
Empty fuel tank/Lack of fuel
Choke has not been used
Wrong fuel, storing without petrol tank
being drained
Sooted spark plug (carbon residues on
electrodes), electrodes distance too big.
The spark plug is wet from petrol
(oversaturated engine).
Sooted spark plug (carbon residues on
electrodes), electrodes distance too big.
Dirty air filter
Bad fuel/oil mix (too much oil)
Regularly clean the outer part
Let regularly checked by authorized workshop
Check for cracks and fissures
Let regularly sharpen
Clean regularly
Regular functional test
Regular functional test (Chain can not move in idle run).
Check for damages and sharpness
Check the chain tension
Functional test
Functional test
Functional test
Check for tightness
In case damage let repaired in authorized workshop
Clean the oil top-up opening
Clean above all guiding oil groove
Drain
Dismount, clean and lubricate slightly by oil Clean the
saw guiding groove
Cleaned chain saw store safely in dry room - out of
children reach.
Removal
Add some fuel
Use the choke
Drain the fuel tank and carburettor.
Add fresh petrol.
Clean the spark plug, check the plug
thermal value, possibly change the plug,
set the electrodes distance to 0.6-0.7 mm
17
Dry the spark plug out and refit it.
17
Clean the spark plug, check the plug
thermal value, possibly change the plug,
set the electrodes distance to 0.6-0.7 mm
17
Clean or replace the air filter
Add some fuel
ENGLISH
10
12
16
10
33