Jonsered CS 2188 Manuel D'utilisation page 41

Recommended cutting equipment for Canada
The following is a list of recommended cutting equipment for Class 1A and 1B Chainsaws. The combinations of
powerhead, bar and chain meet all requirements outlined in the CSA Z62.1-95 Chainsaws and Z62.3-96 Chainsaw
Kickback standards.
The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the
corresponding maximum nose radius of a solid bar.
As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list.
For guide bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of
sprocket teeth may be considered to have equivalent kickback energy.
A hard nose bar having the same length and nose radius as a sprocket-nose bar may be considered to have equivalent
or less kickback energy than the sprocket-nose bar.
We recommend that you as replacement use the listed bars and chains or "Type C Low-Kickback Saw Chains" which
are available at your dealer.
Length, inch Pitch, inch
18-28 3/8
Note: For the chains above you are free to choose between 0,050", 0,058" and 0,063" gauge drive link for the
corresponding bar, see the table below.
0,050"/1,3 mm
0,058"/1,5 mm
Saw chain filing and file gauges
TECHNICAL DATA
Guide bar
Gauge, inch
0,058
H46 H47
H42 H48
Max. nose radius Type
Jonsered H42,
11T
Jonsered H48
Saw chain
Drive link count
68-93
English – 41