Publicité
Les langues disponibles
Les langues disponibles
6. Overhead Assembly: Adjust overhead to 114"
between centerline of sheave pins, Fig. 6. Install (4)
3/8"-16NC x 2-3/4" Flanged HHCS & Flanged Locknuts, do
not tighten. Install overhead stiffener angle inside center
of overhead using (4) 3/8"-16NC x 1" Flanged HHCS and
Flanged Locknuts, see Fig. 6. Slide switch box over switch
bar ensuring lockout holes face the power unit column.
Use (2) 1/4"-20NC x 2-3/4" lg. HHCS, (2) flat washers, (2)
3/4" spacers, and (2) 1/4" star washers and nuts to mount
switch box to overhead, Fig. 7a and Fig. 7b.
Note: For Fig. 6, see Pg. 4 for Hummer (5W0/7W0 Series) Lifts.
1 & 3 Phase Lifts
(2)3/8"-16NC x 3/4" HHCS & Flanged Locknut
1/4"-20NC x 2-3/4" HHCS & 1/4" Locknut
(2)Spacers
Open Bar Side
Fig. 6
All manuals and user guides at all-guides.com
1/4"-20NC x 2-3/4" HHCS, Flat Washer, and Nut
114"
Hardware Detail For Overhead Assembly
1/4" Lock Nut
Spacer
2 Spacers
1/4"-20NC x 2-3/4" HHCS
HOLE
DETAIL
SPO12
7. For single phase and three phase lifts with push
button control box: Insert (2) 1/4"-20NC x 2-3/4" HHCS
through pivot hole in end of switch bar. Insert opposite
end of bar through slot in switch mounting bracket. Then
dd spacers between the limit switch box and the
a
overhead
, Fig. 6, using (2) spacers and
1/4"-20NC Locknut. Tighten Hex bolt leaving 1/16" gap
between the spacer and the overhead assembly.
(4)3/8"-16NC x 1" Flanged HHCS and Flanged Nuts
Switch Box Side
8
Star
Washer
11-3/4"
This Side
Spacer
1/4" Lock Nut
1/4" Star Lock
Washer
1/4" Flat
Washer
1/4"-20NC x 2-3/4" HHCS
Publicité
