Toro Z Master HDX SD 2000 Serie Manuel De L'utilisateur page 61

Removing the Mower Deck
1. Park the machine on a level surface, disengage
the blade-control switch (PTO), and engage the
parking brake.
2. Shut off the engine, remove the key, and
disconnect the spark-plug wires from the spark
plugs.
3. Place the height-adjustment pin in the 7.6 cm (3
inch) cutting-height location.
4. Remove the belt covers.
5. Loosen the mower deck idler and remove the
mower belt; refer to
6. Remove the bolts and nuts from the front of the
plate under the footrest.
7. Remove and retain the bolts and nuts on both
sides of the machine
Figure 81
1. Remove the nuts and bolts here.
2. Remove the nuts and bolts here.
8. Slide the deck out to the right side of the
machine.
Belt Maintenance (page
(Figure 81).
Cleaning
Cleaning under the Mower
Deck
Service Interval: Before each use or daily
1. Park the machine on a level surface, disengage
the blade-control switch (PTO), and engage the
parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
47).
operating position.
3. Raise the mower deck to the T
position.
Cleaning the Suspension
System
Use compressed air to clean the suspension system.
Note:
Do not clean the shock assemblies with
pressurized water
g036866
Disposing of Waste
Engine oil, batteries, hydraulic fluid, and engine
coolant are pollutants to the environment. Dispose of
these according to your state and local regulations.
59
RANSPORT
(Figure 82).
Figure 82
g195820