Toro Z Master HDX SD 2000 Serie Manuel De L'utilisateur page 26

Operating the Mower
Blade-Control Switch (PTO)
The blade-control switch (PTO) starts and stops the
mower blades and any powered attachments.
Engaging the Blade-Control
Switch (PTO)
Note:
Engaging the blade-control switch (PTO) with
the throttle position at half or less causes excessive
wear to the drive belts.
Figure 19
Disengaging the Blade-Control
Switch (PTO)
Figure 20
Operating the Throttle
You can move the throttle control between F
S positions
LOW
Always use the F
Operating the Choke
Use the choke to start a cold engine.
g008945
1. Pull up the choke knob to engage the choke
before using the key switch
2. Push down the choke knob to disengage the
choke after the engine has started
g009174
1. O position
N
24
(Figure 21).
position when engaging the PTO.
AST
Figure 21
(Figure
Figure 22
2. O position
FF
and
AST
g008946
22).
(Figure 22).
g008959