Toro Z Master HDX SD 2000 Serie Manuel De L'utilisateur page 51

Figure 64
1. Idler pulley
2. Idler-spring post
3. Engine pulley
9. Install the clutch stop
10. Install the mower belt; refer to
(page 47).
g036859
4. Pump-drive belt
5. Right hydraulic-pump
pulley
6. Left hydraulic-pump pulley
(Figure 63).
Belt Maintenance
Controls System
Maintenance
Adjusting the
Control-Handle Position
If the ends of the levers hit against each other, refer to
Adjusting the Motion-Control Linkage (page
Adjusting the Height
You can adjust the motion control levers higher or
lower for maximum comfort.
1. Park the machine on a level surface, disengage
the blade-control switch (PTO), and engage the
parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Remove the hardware holding the control lever
to the control-arm shaft.
1. Bolts
2. Slotted hole
4. Move the control lever to the next set of holes.
Secure the lever with the hardware.
5. Repeat the adjustment for the opposite control
lever.
49
50).
Figure 65
3. Control lever
4. Control-arm shaft
g035858