Toro Z Master HDX SD 2000 Serie Manuel De L'utilisateur page 40

6. Slowly pour approximately 80% of the specified
oil into the filler tube and slowly add the
additional oil to bring it to the Full mark
44).
Figure 44
7. Start the engine and drive to a flat area.
8. Check the oil level again.
Changing the Engine-Oil Filter
1. Drain the oil from the engine; refer to
the Engine Oil (page
2. Change the engine-oil filter
(Figure
Changing
37).
(Figure 45).
g027660
Note:
Ensure that the oil-filter gasket touches
the engine, and then turn the oil filter an extra
3/4 turn.
3. Fill the crankcase with the proper type of new
oil; refer to
Servicing the Spark Plug(s)
Service Interval: Every 100 hours
Ensure that the air gap between the center and side
electrodes is correct before installing the spark plug.
Use a spark plug wrench for removing and installing
the spark plug and a gapping tool or feeler gauge to
check and adjust the air gap. Install a new spark plug
if necessary.
Type of Spark Plug: NGK
Air Gap: 0.75 mm (0.03 inch)
Removing the Spark Plug(s)
1. Park the machine on a level surface, disengage
the blade-control switch (PTO), and engage the
parking brake.
38
Figure 45
Engine-Oil Specifications (page
® BPR4ES or equivalent
g027477
36).