Toro Z Master HDX SD 2000 Serie Manuel De L'utilisateur page 47

Adjusting the Tracking
1. Disengage the blade-control switch (PTO).
2. Drive to an open, flat area and move the
motion-control levers to the N
position.
3. Move the throttle midway between the F
S positions.
LOW
4. Move both motion-control levers forward until
they both hit the stops in the T-slot.
5. Check which way the machine tracks.
6. If the machine tracks to the right, insert a 3/16
inch hex wrench through the access hole in the
right front cover panel and rotate the tracking
screw clockwise or counterclockwise to adjust
the travel of the lever
7. If the machine tracks to the left, insert a 3/16
inch hex wrench through the access hole in the
right front cover panel and rotate the tracking
screw clockwise or counterclockwise to adjust
the travel of the lever
8. Drive the machine and check the full forward
tracking.
9. Repeat the adjustment until the desired tracking
is obtained.
Figure 56
Right control lever shown
1. Access hole on front cover
panel
-
EUTRAL LOCK
and
AST
(Figure 56).
(Figure 56).
g035859
2. Tracking screw
Checking the Tire Pressure
For Machines with Pneumatic
Tires Only
Service Interval: Every 50 hours/Monthly (whichever
comes first) For machines with
pneumatic tires only.
Maintain the air pressure in the caster tires and rear
tires at 90 kPa (13 psi). Uneven tire pressure can
cause uneven cut. Check the tires when they are cold
to get the most accurate pressure reading.
Checking the Wheel Lug
Nuts
Check and torque the wheel lug nuts to 122 to 136
N∙m (90 to 100 ft-lb).
45
Figure 57
g001055