Toro Z Master HDX SD 2000 Serie Manuel De L'utilisateur page 60

1. Blades front to rear
2. Blade tip
8. Set the anti-scalp rollers to top holes or remove
them completely for this adjustment.
9. Place 2 blocks (see Block Height and Rake
Table) under the rear edge of the cutting deck
skirt; 1 on each side of the cutting deck
79).
10. Set the height-of-cut lever to the 76 mm (3
inches) position.
11. Place 2 blocks under each side of the front edge
of the deck, but not under the anti-scalp roller
brackets or welds.
Bottom view
1. Rear blocks—78 mm
(3-1/16 inches)
2. Welds
Figure 78
3. Measure from the tip of the
blade to the flat surface
here.
Figure 79
3. Front blocks—73 mm
(2-7/8 inches)
Block Height and Rake Table
Block Height
Front blocks—73 mm (2-7/8
inches)
Rear blocks—78 mm
(3-1/16 inches)
12. Carefully rotate the blades side to side
79).
13. Loosen the locknuts
and ensure that the mower deck is sitting
securely on all 4 blocks.
14. Remove any slack from the deck hangers and
make sure the deck-lift foot lever is pushed back
g329619
against the stop.
15. Tighten the 4 locknuts.
(Figure
1. Locknuts
2. Deck lift arm
16. Ensure that the blocks fit snugly under the deck
skirt and that all attachment bolts are tight
17. Continue leveling the deck by checking the
front-to-rear blade slope.
18. Check the blades for levelness and repeat deck
leveling procedure if necessary.
g329631
58
Rake
6.4 mm (1/4 inch)
(Figure 80) on all 4 corners
Figure 80
3. Deck hanger
4. Chain
(Figure
g035851