Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Safety
Important Safety Instructions
SAVE THESE INSTRUCTIONS - This manual contains
important instructions that should be followed during
installation, operation, and maintenance of the product.
Save this manual for future reference.
This is the safety alert symbol. When you see this
symbol on your pump or in this manual, look for one of
the following signal words and be alert to the potential
for personal injury!
indicates a hazard which, if not avoided, will
result in death or serious injury.
indicates a hazard which, if not avoided,
could result in death or serious injury.
indicates a hazard which, if not avoided,
could result in minor or moderate injury.
NOTICE addresses practices not related to personal injury.
Carefully read and follow all safety instructions in this
manual and on pump.
Keep safety labels in good condition.
Replace missing or damaged safety labels.
Make workshops childproof; use padlocks and master
switches; remove starter keys.
California Proposition 65 Warning
This product and related accessories
contain chemicals known to the State of California to
cause cancer, birth defects or other reproductive harm.
General Safety
1. To avoid risk of serious bodily injury and property
damage, read the safety instructions carefully before
installing this pump.
2. Follow local and/or national plumbing and electrical
codes when installing the pump.
3.
Hazardous Pressure. The pump body
may explode if used as a booster pump unless a
relief valve capable of passing the full pump flow at
75 PSI (517 kPa) is installed.
4. Never run the pump dry. To do so can damage
internal parts, overheat pump (which can cause
burns to people handling or servicing pump), and
will void warranty.
5.
Risk of fire or explosion. To avoid risk
of fire and explosion, Pump Water Only with this
pump. Do not use this pump in an atmosphere that
might contain flammable fumes or vapors.
6.
Burn Hazard. If water is trapped in the
pump during operation it may turn to steam. Trapped
steam can lead to an explosion and burns. Never run
the pump with the outlet closed or obstructed.
7.
Burn Hazard. Do not touch an
operating motor. Modern motors can operate at
high temperatures. To avoid burns when servicing
the pump, allow it to cool for 20 minutes after shut-
down before handling.
Electrical Safety
The pump is supplied with a 3-conductor grounding
type cord. Connect only to a properly grounded,
GFCI protected outlet. Do not lift the pump by the
electrical cord.
Hazardous voltage. Can shock, burn or
cause death. Ground pump before connecting to power
supply. Disconnect power before working on pump,
motor or tank.
The pump is non-submersible. Keep the motor dry at all
times. Do not wash the motor. Do not immerse. Protect
the motor from wet weather.
If using an extension cord, use only a UL approved
indoor/outdoor, 3-wire, grounding type cord. Do not
allow any part of the cord or the receptacle ends to sit in
water or in damp locations.
Unplug the pump before servicing. To avoid fatal shocks,
proceed as follows if the pump needs servicing.
A. Disconnect the power to the pump outlet box before
pulling the pump plug. After the plug is pulled, let
the pump cool for 20 minutes before attempting to
work on it.
B. Take extreme care when changing fuses. To reduce
the chance of fatal electrical shock, DO NOT stand
in water or put your finger in the fuse socket.
C. Ground electrical outlet box.
D. Plug pump into a Ground Fault Circuit Interrupter
(GFCI) protected grounded outlet only.
2
Publicité
Table des Matières
