Publicité
Les langues disponibles
Les langues disponibles
DESCRIPTION
1
Handles
Accelerator
3
Dash-board
4
Rod
5
Transport wheels
6
Hoeing blades
7
Protection guard
8
Fuel tank
9
Spark plug
10
Engine startgrip
11
Reduction gear
ASSEMBLY
MOD. 1
(Fig.B
)
I
MOD. 2
(Fig.B
)
II
MOD. 4
(Fig.B
)
III
ASSEMBLY OF: HANDLES - SKID - WHEEL - ACCE-
LERATOR LEVER - OFF-SWITCH.
Handles (1): mount handle-plate (1) in the frame (3)
and fix it with four screws, washers and nuts (24). Now
introduce the two handles (1) into the handle-plate and
fix them with screws, washers and wing screws(25).
SAFETY DURING USE
Before you start working, make sure to remove
any objects or obstacles that may have been left
on the lawn.
ENGINE ADJUSTMENTS
Refer to the engine manufacturer's maintenance
manual.
ADJUSTMENT OF HANDLES
MOD. 1
(Fig.E
I
MOD. 2
(Fig.E
II
MOD. 4
(Fig.E
III
All manuals and user guides at all-guides.com
)
(starts at page II
(for the models where it is included only)
)
)
)
1
Clutch lever
13
Reverse lever
14
Side disk
15
Oil filler cap
16
Oil drain plug
17
START/STOP switch
18
Filter cap for gearbox
19
Drain plug for gearbox
0
Motor
21
Handle plate
22
Safety handle
Skid (4): indroduced the skid into the seat an the frame
(23) and fix with cotter pin (26).
Wheel (5): Mount the wheel rod (7) an the frame (3)
and then fix with screw, washer and nut (28). Introduce
cotter pin (9).
Accelerator lever (Governor) (): (this refers only to the
version with 4-stroke engine). Fix the governor to the
handles (1) by means of screw and nut (30).
Switch (17): (this refers anly to the version with -stroke
engine). Introduce the terminals of grounding cables (31)
into the fixing spots of the switch.
MOD. 4
(Fig.B
)
IV
The operator is responsible for the safety of other people
in the working area.
CAUTION:- 0.6l Oil must be added to the engine before
use.
3
ENGLISH -
Publicité
