Publicité
WLAN configuration
"SSID" (Service Set Identifier) The name that identifies the wireless network. The access point and
the WLANnetwork camera must use the name SSID. The factory setting is "default". IMPORTANT:
The max. length is 32 characters; do not use: " , ", <, > and spaces.
"Wireless mode" Select one of the following:
"Infrastructure" Thenetwork camera is connected to the network via an access point.
"Ad-Hoc" In this mode, thenetwork camera can communicate direct with another network
adapter (network card). A so-called Peer-to-Peer environment is set up.
"Channel" In infrastructure mode, the channel used is selected automatically by the camera. In Ad-
Hoc mode, the channel must be set manually according to the other network adapter.
"TX rate" Set the maximum transmission speed in the network. In the factory, the speed is set to
select automatically ("auto"), and the camera always tries to reach the highest transmission speed
according to the environment.
"Preamble" A so-called preamble is set before each data packet. This preamble is used to
synchronise the receiver and the sender. With a "short preamble", the synchronisation length is shorter
and therefore not so secure.
"Security" Select the encryption method:
"None" No encryption selected.
"WEP" (Wired Equivalent Privacy) A 64- or 128-bit key is used for encryption (HEX or ASCII).
For communication with other equipment, these keys must be the same on both devices.
"WPA-PSK/WPA2-PSK" (Wi-fi Protected Access – Pre Shared Keys) With this method,
dynamic keys are used. As encryption protocols, TKIP (Temporal Key Integrity Protocol) or
AES (Advanced Encryption Standard) can be selected. A so-called Pre-Shared Key must be
defined.
"Auth mode" Authentication mode: Select one of the following methods:
"Shared" This mode permits communication only with equipment using the same WEP key.
"Open" The key is communicated over the whole network.
"Key length" Select 64 or 128 bit.
"Key format" Key format
"HEX" Hexadecimal format
"ASCII" ASCII format
"Network key" For different key formats, different key lengths are expected.
64 Bit: 10 hex digits or 5 characters
128 Bit: 26 hex digits or 13 characters
IMPORTANT: If you want to use characters 22 ("), 3C (<) or 3E (>), you cannot use ASCII
format.
"Pre-Shared-Key" Enter this key in ASCII format with a length of 8 ~ 63 characters.
Incorrect settings may prevent access to the camera. If the system can no longer be
addressed, read the notes on restoring the factory settings in the appendix.
All manuals and user guides at all-guides.com
24
Publicité
