Publicité
Access to the network camera via the Internet Explorer
Defining a password to prevent unauthorised access
When delivered, no administrator password is defined for the network camera.
The network camera asks for this number at the start of operation. For security reasons, the
administrator should define a new password immediately. After the new administrator password is
stored, the network camera asks for the user name and password every time it is accessed. The
administrator can define up to twenty (20) user accounts. Every user has access to the network
camera, but not to the system configuration. Some system-critical functions are reserved for the
administrator, such as system configuration, user administration and upgrading software programs.
The administrator's user name is always root and cannot be changed. Following a password change,
the browser displays an authentication window and asks for the new password. After changing the
password, you cannot restore the original administrator password. Your only option is to reset all
default factory settings/parameters.
To enter a password:
Open the Internet Explorer and enter the IP address of the camera (e.g.: <http://192.168.0.99>).
You are prompted for authentication:
You are now connected with the network camera and can see a video stream.
Note: It may happen that your PC's security settings prevent a video stream. You can
change the security settings to a lower level under "Tools/Internet Options/Security". Make sure
you enable Active X Control Elements and Downloads.
All manuals and user guides at all-guides.com
9
Publicité
