Publicité
Appendix
A. Troubleshooting
Status LEDs
Condition / LED Color
System start
During boot up
Network search/setup
Network ok
During Firmware Upgrade
Resetting and restoring
At the back side of the netzwork camera is a button. Press this button to reset the system or restore
the factory parameter settings. Sometimes the normal system status can be restored by a reset. If you
have further problems following a reset, restore the factory parameter settings and reinstall and
reconfigure the system.
RESET:
Press the reset button with a pointed object.
RESTORE:
1. Press the button continuously with a pointed object.
2. Wait until the LEDs blink fast.
3. Release the reset button.
All manuals and user guides at all-guides.com
Green
On
Off
On
1/s
1/s
If the factory parameter settings are restored, all
the previous settings are deleted. The system can be
reset or restored.
Reset button
37
Red
1/s (once)
1/s
Off
On
0.1/s
Publicité
