Proxxon FF 400 Manuel page 13

Description of the machine
Construction
The PF/FF 400 is a so-called vertical stand milling ma-
chine. A stable, generously sized column accommoda-
tes the milling head consisting of motor, gearbox and
spindle unit. Also fitted are the drill feed on the milling
head itself as well as the hand wheel feed on the co-
lumn for the precise adjustment of the machining
height. The drill feed also allows drilling work to be car-
ried out. The electrical equipment is accommodated in
the gearbox and the operator controls are situated on
the front of the gearbox. The milling unit can optionally
be combined with a compound table (supplied with the
KT 400 as the FF 400, but can also be used with the
KT 250) or with the PD 400 lathe system (PF 400). In
this case, the milling machine can be screwed to the
machine bed and the milling table provided with it is fi-
xed on the support of the lathe.
The following options are available in the fine milling
system 400:
Scope of supply
KT 400:
Compound table
Operating manual and safety instructions
PF 400:
Milling spindle complete with motor and belt drive
Column (Ø 45mm)
Fixing block for lathe (not included in the scope of
supply with the FF 400)
Collets Ø 6, 8, 10 and 12 mm including union nut
Milling table with T-slots (150x110 mm, not included in
the scope of supply with the FF 400)
Operating tool
Operating manual and safety instructions
FF 400:
Includes the PF 400 miller complete with KT 400 com-
pound table but without the milling table, Item 16, and
the mounting foot, Item 12, in Fig. 1.
All manuals and user guides at all-guides.com
General Arrangement, milling machine
PF 400 (Fig. 1)
1. Motor
2. Cover
3. On/Off switch
4. Changeover switch
5. Table
6. Knurled screw for cover
7. Union nut for collet
8. Clamping screw for quill
9. Scale for depth adjustment
10. Drilling lever
11. Column (ø 45 mm)
12. Fixing block for lathe
13. Hand wheel for height adjustment with fine feed
14. Clamping screw for height adjustment
15. Scale for angle adjustment
16. Milling table for PD 400 lathe
(Items 12 and 16 are not included in the scope of supply
of the FF 400 milling machine but only with the PF 400)
General Arrangement, compound table KT 400
(Fig. 2)
1. Hand wheel for X-direction (travel 310 mm)
2. Work table (400 mm x 125 mm)
3. Adjusting screws for Y-guide
4. Screw holes for fixing
5. Foot
6. Hand wheel for Y-direction (travel 80 mm)
7. Support
8. Column clamping screws
9. Linear scale
10. Adjusting screws for X-guide
Technical data for PF 400 milling machine
Voltage: 220 – 240 Volt, 50/60 Hz
Power: 400 Watt
6 spindle speeds determined by belt position:
180, 350, 550, 800, 1300 and 2500/min
Quill stroke: 30 mm
Vertical adjustment: ca. 300 mm
Feed: 1,5 mm/revolution
Noise: ≤ 70 dB(A)
Vibration: ≤ 2.5 m/s2
Dimensions see Fig. 3
Weight: ca. 15 kg
- 13 -