Maxi-Cosi CabrioFix Mode D'emploi page 40

EN
1 Shell
2 Belt buckle
3 a Crotch strap with belt pad
3 b Shoulder belts with belt pads
4 Slots to adjust shoulder belts
5 Seat reducer
6 Carrying handle
7 Push button for adjusting carrying handle
8 Belt hook for lap section of safety belt
9 Rear belt hook for shoulder section of
safety belt
10 Belt tensioner strap
11 Control button of the quick adjuster
12 Control button for removing car seat
from stroller frame
13 Shoulder pad hooks
14 Instructions and airbag warning sticker
15 Rim (for storing sun canopy)
16 Sun canopy (built-in)
17 Instruction manual
18 Storage compartment
19 Mounting bars for base
SAFETY
General instructions
1. The CabrioFix is developed for an intensive use
of approximately 10 years.
2. We advise to check the expanded polystyrene
(EPS) parts regularly for damages.
I I
42 CabrioFix Maxi-Cosi
WARNING:
• Children have STRANGLED in loose or partially
buckled harness straps. Fully restrain the child
even when carrier is used outside the vehicle.
• Never place the CabrioFix on an elevated
surface (such as a table or chair).
• The CabrioFix may only be installed in a rear-
facing position in the car.
CabrioFix and your baby
1. Make sure you can fit no more than one finger
between the harness and your baby (1cm).
2. Only use the seat reducer of the CabrioFix
when the shoulder belts are in the lowest
position.
CabrioFix car use
1. Make sure the car safety belt buckle runs in
a straight line and stays below the belt hook of
the car seat.
2. The car safety belt must be threaded along
all blue markings. For proper installation, follow
the car installation instructions in this manual
or on the sticker on the side of the CabrioFix
carefully.
CabrioFix in airplanes
• Installation of the CabrioFix on an aircraft seat
di ers from the installation on a car seat.
• Installing the CabrioFix with a 2-point safety
belt is only allowed when used in an aircraft.
• In an aircraft, the CabrioFix may only be used
on forward-facing passenger seats.