Trotec IDE 30 Manuel D'utilisation page 17

12. Transport
• Switch the device off as described in the chapter
"Functions and operation".
• Wait until the device has cooled down completely.
• Before transporting or adjusting the device, check
if the tank cap is tightly closed.
m Risk of environmental pollution! Heating oil
may leak during transport or handling of the
device. The filling plug of the tank cap does
not guarantee tightness in order to allow air
to be introduced and the tank to be emptied
during operation. Only transport or shift the
device with the tank cap tightly closed.
13. Care and maintenance
In order to ensure a trouble-free operation of the de-
vice, the combustion chamber, the burner and the fan
are to be cleaned regularly.
• Switch the device off as described in the chapter
"Functions and operation".
• Wait until the device has cooled down completely.
Cleaning after every 50 operating hours
• Dismount the heating oil filter. Remove the filter in-
sert and clean it using clean heating oil.
• Dismount the upper housing part and clean the in-
ner part as well as the fan blades using a cleaning
fleece and a brass brush if it is heavily soiled.
• Check the condition of all cables and high-voltage
connections.
• Dismount the burner and clean its components us-
ing a brass brush.
• Clean the electrodes. Check the distance of the
electrodes and adjust it if required (see figure).
EN
• Have the combustion chamber cleaned by the cus-
tomer service.
• Mount the components in the reverse order.
Cleaning the oil heating unit
• Wipe the exterior of the device using a wet cloth. The
painted and plastic surfaces may not be scoured. Do
not use any solvent-based cleaning agents.
14. Disposal
The heating oil must be drained from the tank of the
oil heating unit and collected.
Oil heating unit
Electronic equipment may not be disposed of in the
domestic waste, but must be correctly disposed of in
accordance with the EUROPEAN PARLIAMENT direc-
tive 2002/96/EC of 27th January 2003 regarding used
electrical and electronic equipment. Please dispose of
this device according to the applicable legal regula-
tions after its final decommissioning.
Heating oil
Fuels must be disposed of according to the local
regulations.
Packaging
The packaging of the oil heating unit consists of card-
board/paper and plastic. The materials must be dis-
posed of in the designated containers according to
the local regulations or at a recycling depot.
15. Service and repair
Before contacting our customer service in order to
solve an existing technical problem, please try remov-
ing the error by following the instructions described in
the chapter "Troubleshooting".
If you have any further questions regarding the func-
tioning and operation of the oil cleaning unit or if you
wish to receive further information in the event of a
claim or with regard to guarantee aspects, please do
not hesitate to contact us at any time.
Please contact:
Trotec GmbH Co KG • Grebbener Straße 7
D-52525 Heinsberg • Tel.: +49 2452 962 - 400
Fax.: +49 2452 962 - 200
Email: info@trotec.de www.trotec.de.
Operating Manual – IDE 30 / 50 / 60
B - 7