Publicité
Les langues disponibles
Les langues disponibles
LIFT
- Buffet - Sideboard - Aparador
design Sacha Lakic
5. CHANGE OF THE LEDS OF THE FRONT
It is necessary to separate the mobile part from the piece of furniture. Follow the steps of the chapter 4 until
2.3 included.
1. Put 2 other wedges over the jacks to be able to raise it 60cm higher, be careful to not have
obstacle over the sideboard (Fig.14a)
2. Trigger the rise with the remote control or the button. Now you can access to the inside of the
corpus (Fig.14b)
Fig 14a
3. Press on the bottom of the cover located at the top of the relief shape, inside the corpus to take it off
4. Remove the piece in shape of « banana », using as support of the leds (Fig.15).
5. Replace the LED strip, replace the piece in shape of "banana" and the cover as well
6. Descend the jacks to the bottom
7. Put again the mobile part of the sideboard on the retainer wedges in order to enable the jacks to
come in their previous place
8. Make sure that the jacks are perfectly put in their place
the manual switch located under the sideboard at the left side (see chapter 2 of the general
assembling instructions).
9. To do little rises, press to do the rise and instantly press again to one button or another, this will
stop the rise of the jacks.
10. Remove the retainer wedges raising at 2 people by the superior top at the level of the columns
11. Approach the 4 screws by jacks, do not tighten them completely (fig. 7)
They must not face to any opposition.
6
Fig 14b
and rise them with the remote control or with
Publicité
